Micro Ringmaster

Here is plan for. 22” Baby Ringmaster. Print it out at a litte under 50% to get 10” WS.

Not sure is the MIcro ringmaster a slab wing?

https://outerzone.co.uk/plan_details.asp?ID=5652

The Micro Ringmaster is a scaled down slab wing version of an S1. So it’s not as simple as shrinking a Baby Ringmaster.

Rusty probably has plans as he built one. To be honest though you could probably go to the PDK section on Stunthangar and take a look for the outline. It would be simple to cut one out of a 3 side view. Have you a membership on Brotherhood of the Ring?

Edit: This should work for you, just blow it up until you get a 10.5” wingspan.

http://pdkllc.com/micro-ringmaster-21-50/




Ron

Yes, the micro is a sheet wing at 10.5". Thanks for teh help and advice. I did manage to find a blurry picture online and have printed it out now. Should be good enough to build from. We'll see... Stay tuned.

I edited my original post. It should print out much cleaner.

Thank you all. I got most of it cut out now. Just waiting for teh wing to dry as I had to splice 2 pieces together to make the correct width. I only had a small odd shaped piece of 3/32" balsa.

Well, this was tonights venture. Here is where I am at right now. Just a few small details left. Bellcrank button, and leadout guide. Doping will hopefully get done tomorrow, weather permitting.


I think a Black Widow may be a bit too much???? Lol.

NEW222 wrote:Well, this was tonights venture. Here is where I am at right now. Just a few small details left. Bellcrank button, and leadout guide. Doping will hopefully get done tomorrow, weather permitting.


I think a Black Widow may be a bit too much???? Lol.

........
...................Friend, I would like to see you flying the micro with the Tee Dee .010 soon .... what a wonderful engine!

First, thank you all for teh kind words. It is greatly appreciated.

As for the build, it is just plain old scrap wood I had laying around. The wing is just flat 3/32" balsa with no airfoil, fuselage is 3/16" balsa, tail surfaces are 1/16" balsa, and for a first time the tail is hinged with fabric and Ambroid, a first for me.... And as for power, I do not have any immediate plans for flying it as I do not have a TD .010. So until that day comes, it will be built and ready to take to the skies. I will weigh it after it is finished and I may have an old HZ Champ I may rob the motor from and electrify it using teh radio for throttle.....

And I almost forgot. Thanks for the link. Going there to read it now!