Carl Goldberg POSTAGE STAMP mount wanted..

I'm sure that someone here can hook you up with either Roddie's bent aluminum mount or Jason's 3D printed mount.  I've made several mounts for the postage stamp engines for various uses.  But if you want just a dead simple mount for a postage stamp, all you need is a small strip of 1/16" aluminum and some #2 washers or spacers.  Won't be pretty, but it'll work.  Make the length of the strip the size you want the mount.  Probably the length of the long side of a Bee tank back.  Then, file down the center a little bit and slot it for the needle valve assembly, like the center of the C.G. mount.  Drill the four holes for the 2-56 crank case screws.  Then, at the corners of the mount you drill four holes that correspond with the Bee mounting holes.  Then attach the mount with several #2 washers or spacers between the plate and the firewall.  Just enough to clear the postage stamp venturi tube from the firewall.  I don't have a photo of one, but I'll make a terrible drawing to illustrate.  If you can figure out my drawing, you can make the mount.






The Picasso Mark