Log in
Search
Latest topics
» Fox .35 Modifications by Onelife Today at 3:04 pm
» Happy Anzac Day!
by GallopingGhostler Today at 2:44 pm
» Revivng Some Childhood Classics
by rsv1cox Today at 9:17 am
» Introducing our Cox .049 TD Engines
by getback Today at 8:20 am
» Project Cox .049 r/c & Citabrian Champion
by getback Today at 8:17 am
» Roddie's flat-bottomed boat..
by Levent Suberk Today at 2:23 am
» Cox powered jet-pump for model Sprint Boat
by roddie Today at 12:25 am
» Micro Draco Gets to Fly on a Beautiful Morning.
by rdw777 Yesterday at 10:15 pm
» Jim Walker Firebaby
by rdw777 Yesterday at 10:06 pm
» Hydro-bat by Vic Smeed: engine probs
by GallopingGhostler Yesterday at 7:12 pm
» Roddie-Rigger.. a 2005 original design
by roddie Yesterday at 5:39 pm
» [solved]most Efficent Glowhead Clip for Norvel Engine
by batjac Yesterday at 12:33 am
Cox Engine of The Month
Just the way I like them....
Page 1 of 1
Re: Just the way I like them....
Ooh woo, me likey. Nice score Travis.
Should clean up nicely. If you tear it down,
Let us know what you find.
Bob
Should clean up nicely. If you tear it down,
Let us know what you find.
Bob
dckrsn- Diamond Member
- Posts : 2750
Join date : 2010-10-21
Age : 71
Location : Long Island, New York
Re: Just the way I like them....
Travis is that the one were the guy made his on carb? that will make a nice keeper , you going to put it in the air ? I would like to hear it run if you do please post . Eric
getback- Top Poster
-
Posts : 10114
Join date : 2013-01-18
Age : 66
Location : julian , NC
Re: Just the way I like them....
No, this one you had to know what you were looking at to know what it exactly was. I ended up buying a Queen Bee from him as well, but it needs a new cab assembly.
http://www.ebay.com/itm/331454336264?_trksid=p2059210.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
http://www.ebay.com/itm/331454336264?_trksid=p2059210.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
Re: Just the way I like them....
I'm going to rebuild it and get it running, video to come. I'm not sure when though....
Re: Just the way I like them....
You may need the small O-ring which sits on the needle-valve steam and seals against unwanted air ingress, replaced. I would also pull a bit on the retainer springs on the air-bleed and throttle limiting screws as these tend to be lose and the aluminum carb body has a soft thread which inherently widens up due to vibration, with the screws lost sooner or later.
Sorry for the unsolicited advice...the TD050-freak balogh
Sorry for the unsolicited advice...the TD050-freak balogh
balogh- Top Poster
-
Posts : 4745
Join date : 2011-11-06
Age : 65
Location : Budapest Hungary
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum